Digital Magazine

Ink 101: Part I

It is estimated the total North American (US and Canada) market for packaging materials is approximately $125 billion in annual shipments. Ink is a relatively minor cost component of the packaging, yet it is the primary link to the consumer market in terms of shelf appeal and consumer acceptance.

During converting operations, ink management as a discipline is a key to productivity and low waste. The table below shows a breakdown of ink usage, which is small in comparison to the total for packaging.

Ink Sales by Market Segment and Print Method ($M)
Item Flexo Offset Gravure Total
Total 1,260 310 230 1,800
Corrugated 360 30 NA 390
Flexible Packaging 660 NA 125 785
Folding Carton 80 200 80 360
Label 160 80 25 265

There are three main printing processes used in packaging: flexo, gravure, and litho. There are four different ink chemistries used: water-based, solvent-based, oil-based, and energy cured. Not every chemistry is applicable to every printing method. Below is a summary.

Summary of Ink Chemistries And Printing Processes
Printing Processes
Ink Chemistries Flexo Offset Gravure
Solvent Yes No Yes
Water Yes No Yes
Oil No Yes No
Energy Cured Yes Yes No

Typical packaging applications for water-based inks include liquid packaging, aseptic packaging, cups and plates, corrugated containers, multiwall bags, beverage carriers, gift wrap, folding cartons, towel and tissue, and retail bags.

Typical applications for solvent-based inks are bread bags, frozen food bags, candy wrap, snack foods, meat and cheese wrappers, stand-up pouches, and towel/tissue overwrap. Use of water-based inks is almost exclusively for paper and board substrates where adhesion, wetting, and drying are facilitated by the substrate porosity. Solvent-based inks are used on film and foil substrates. Energy-cured inks are fully developed and in day-to-day use for litho printing. Their use in flexo is small but growing.

If we accept that the packaging market is relatively mature and proven in terms of materials and equipment in current use, then what is the basis of competition? If everyone has access to equivalent technology, that leaves us with opportunities for improvement in process design, control, and measurement.

However, all too often materials going into the press are selected in isolation, and when combined in a manufacturing process, they may or may not be conducive to high quality, low cost, and low waste. Ink is a relatively minor cost component with a major impact on converting and often does not get the attention required for optimum performance. Two tough questions for converters are: “What is your waste level, and how does this affect your bottom line?”

In the previous issue, this column discussed process modeling, and the concept of a dynamic workflow of “input-transform-output” was introduced. There are measurable and predictable relationships among ink composition, ink density, ink film thickness, press configuration, press efficiency, print quality, cost of use, and end-use properties. These relationships are controlled by system design and will be explored in upcoming issues of PFFC.

David Argent has 30+ years of experience in the converting industry. He specializes in process analysis and improvement with particular emphasis on ink and coating design and performance. Contact him at 636/391-8180; This email address is being protected from spambots. You need JavaScript enabled to view it.

Sun Chemical HD Plates

Subscribe to PFFC's EClips Newsletter